Petsafe In-Ground Fence™ User Manual download pdf (Page 19)

18 1-800-732-2677 www.petsafe.net 19

To Cross Hard Surfaces (driveways, sidewalks, etc.)

Follow all safety instructions for your power tools. Be sure to always wear your safety goggles.

•Concrete Driveway or Sidewalk (7C): Place the

Boundary Wire in a convenient expansion joint or create

a groove using a circular saw and masonry blade. Place

the Boundary Wire in the groove and cover with an

appropriate waterprooﬁng compound. For best results,

brush away dirt or other debris before patching.

•Gravel or Dirt Driveway (7D): Place the Boundary Wire

in a PVC pipe or water hose to protect the Boundary

Wire before burying.

Place the Boundary Flags

The Boundary Flags are visual reminders for your pet of where the Warning Zone is located.

1. Place the Test Light contacts on the contact

points and hold the Receiver Collar at your

pet’s neck height.

2. Walk towards the Warning Zone until the

Receiver Collar beeps (8A).

3. Place a Boundary Flag in the ground (8B).

4. Walk back into the Pet Area until the beeping

stops.

5. Repeat this process around the Warning Zone

until it is marked with Boundary Flags every

10 feet.

Note: If you cannot hear the beep, see the Test

Light Instructions in Step 6.

Boundary

Wire

To prevent an unintended correction, after the Boundary Flags have been placed, be sure to set the static

correction on the Receiver Collar back to level 1 Tone Only.

Step

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

No comments

Petsafe In-Ground Fence™ User Manual Page 19