Petsafe In-Ground Fence™ User Manual download pdf (Page 27)

26 1-800-732-2677 www.petsafe.net 27

System Test

The system test is used to determine the cause of system problems that have not been addressed elsewhere in this guide.

You will need a piece of Boundary Wire greater than 15 feet long with

⁄

inch of insulation removed from each end to use as

a test loop wire. Make a note of your Boundary Control Switch setting, Boundary Width Control knob setting, and Receiver

Collar setting before beginning the System Test. Follow the steps below to perform the system test:

1. Remove the Receiver Collar from your dog and make sure a good battery is

installed in the receiver.

2. Set the Boundary Control switch to B.

3. Set the Receiver Collar Static Correction Level to 5.

4. Disconnect the twisted Boundary Wire from the Boundary Wire terminals on

the Fence Transmitter by pressing the red release levers on the connector and

pulling the wires free (11A).

5. Insert the two ends of the test loop wire into the Boundary Wire Terminals on the

Transmitter.

6. Turn the Boundary Width control knob to 10 and then back to 5.

7. Place the Test Light Tool Contacts on the Contact Points of the Receiver Collar.

While holding the Receiver Collar with the Test Light Tool in place, approach the

wire from the outside loop 2 inches off the ground. Make a mental note of the

distance where the Receiver Collar activates from the wire.

8. Turn the Boundary Width Control knob to 10 and repeat Step 7. The distance

where the Receiver Collar activates should be greater than the previous result.

9. If more than one Receiver Collar is used on the system, repeat the above test on

each collar.

10. Keep Boundary Width Control Knob position at 10. Set the Boundary Control

Switch to A. Approach loop with Receiver Collar as in Step 7 and verify the

Receiver Collar activates.

11. Keep Boundary Width Control knob position at 10. Set the Boundary Control

Switch to C. Approach loop with Receiver Collar as in Step 7 and verify the

Receiver Collar activates.

12. Interpreting the Results:

a. If the Power light or the Loop indicator light are not both lit on the Fence

Transmitter, or the alarm is on, for any of the above tests, there is a problem

with the Transmitter. Contact the Customer Care Center.

b. If both the Power and Loop indicator lights are on, but the Receiver Collar does

not activate on the test loop wire, the Receiver Collar is not working. Contact

the Customer Care Center.

c. If the Transmitter Power and Loop indicator lights are on in each of the 3

Boundary Control Switch positions and the Receiver Collar is activating at

different distances on the test loop wire, the problem is most likely in the

containment Boundary Wire or Surge Protector. Reconnect the Transmitter

wires to the Surge Protector and connect the Test Loop to the Surge Protector

loop terminals. Repeat steps (6-11) (11B).

13. Interpreting the Results with the Surge Protector:

a. If both the Power and Loop indicator lights are ON and the Receiver Collar

is activating at different distances on the test loop wire, the problem is in the

containment Boundary Wire. Perform the Wire Break Location Test.

11A

11B

System Test

Surge Protector

Unconnected

System Test

Surge Protector

Connected

b. If the Loop indicator light is OFF with an alarm on the Fence Transmitter, there is a problem with the Surge Protector.

Contact the Customer Care Center.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Petsafe In-Ground Fence™ User Manual Page 27

Comments to this Manuals

Related products and manuals for For pets Petsafe In-Ground Fence™