Petsafe In-Ground Fence™ User Manual download pdf (Page 12)

12 1-800-732-2677

1. Turn the power OFF to the outlet that the Surge Protector

and Fence Transmitter will be plugged into.

2. We recommend that, if possible, use the outlet center

screw that holds the cover plate in place to secure the

Surge Protector to the outlet. To do this, tape the top of

the cover plate to the wall, then remove the cover plate

center screw. Plug the Surge Protector into the lower outlet

and then secure the cover plate using the longer screw

included with the protector. The screw is for mechanical

attachment only and does not ground the protector.

Remove the tape and turn ON the power to the outlet.

3. Run the Boundary Wire through a window, under a door,

through a crawl space vent, or any other appropriate

available access. You can also drill a hole through your wall.

Fence Transmitter

Power

Adapter

Red Loop Tabs

Boundary Wires

(Twisted)

Boundary

Wire

Terminals

Transmitter

Wires

(Twisted)

Boundary Wire

Loop

Black

Transmitter

Tabs

LP-4100

Power

Jack

Transmitter

Loop

4. Strip

⁄

inch of insulation from the ends of the Boundary Wire. Insert the stripped ends

into the 2 left red connector holes on the bottom of the Surge Protector labeled “Loop”

(4B). There should be 1 wire in each connector hole. Press the plastic tab, insert the

wires and release the tab. Make sure the wires do not touch each other at the terminals.

Verify that the boundary loop and transmitter wires connect to the

proper Surge Protector terminals. Reversed connections will result in an

increased risk of surge related damage.

5. Determine the length of wire needed to pass from the Surge Protector to the Fence

Transmitter. Measure and cut 2 lengths of wire, then strip

⁄

inch of insulation at both

ends. Twist the 2 lengths together, with at least 10-12 twists per foot, so the wires will

not send out a signal.

LOOP TRANSMITTER

Push Tab

Down

Insert bare end

of wire into

opened slot

and release tab

to lock.

6. Insert the ends of the the twisted transmitter wires into the right 2 black connectors at the bottom of the Surge

Protector labeled “Transmitter”.

7. Press the red plastic tabs on the Fence Transmitter and insert the opposite ends of the twisted wire into the

Boundary Wire Terminals.

8. Turn the Boundary Width Control knob to 10. This will set the Boundary Width at the maximum width.

9. Plug in the transmitter power adapter to the outlet on the front of the Surge Protector.

10. The Power Light and Loop Indicator Lights should come on. If this does not happen, see the “Troubleshooting”

section.

For added protection, when unused for long periods of time or prior to thunderstorms, unplug from the

wall outlet and disconnect the loop boundary wires. This will prevent damage to the transmitter due to

surges.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments

Petsafe In-Ground Fence™ User Manual Page 12

Comments to this Manuals

Related products and manuals for For pets Petsafe In-Ground Fence™