Petsafe In-Ground Fence™ User Manual download pdf (Page 14)

14 1-800-732-2677

Prepare the Receiver Collar

Your Receiver Collar comes with short Contact Points installed. Use the Long Contact Points for

pets with long or thick hair. Tighten the Contact Points using Test Light Tool (5A) one-half turn

beyond finger tight. Check the tightness weekly.

To Insert and Remove the Battery

Note: Do not install the battery while the Receiver Collar is on your pet.

This Receiver Collar utilizes a replaceable PetSafe

battery (RFA-67). This unique battery is

designed to make battery replacement easier and increase water protection.

To insert the battery, align the symbols on the battery (arrow) and Receiver Collar (triangle)

(5B). Use the edge of the Test Light Tool to turn the battery clockwise until the arrow lines up

with the lock symbol on the housing.

To remove the battery, turn the battery counter-clockwise using the edge of the Test Light

Tool (5C). DO NOT attempt to cut into or pry open the battery. Be sure to discard the used

battery properly. Battery life will vary depending on how often your pet tests the system and

receives a Static Correction. Check the Receiver Collar every month to ensure the battery is

working properly.

If the Receiver LED Indicator Light is ﬂashing every 4 to 5 seconds, battery replacement is required. Remove the old

battery from the Receiver Collar. Discharge all power by holding the correction level button down until the LED is

no longer illuminated. Replace with a new battery.

A replacement PetSafe

battery (RFA-67) can be found at many retailers. Contact the Customer Care Center or visit

our web site at www.petsafe.net to locate a retailer near you.

To Set the Static Correction Level

Read all steps before attempting to set the Static Correction Level.

1. Remove the clear plastic cover with the Test Light Tool

to expose the Correction Level Button (5D).

2. With the battery installed, press the Correction Level

Button and release when the Receiver Indicator Light

lights up (5E).

3. The Receiver Indicator Light will emit a series of ﬂashes

representing the Static Correction Level.

4. Increase the Static Correction Level by pressing and

releasing the Correction Level Button within 5 seconds

of the previous series of ﬂashes.

5. After setting the Static Correction Level, replace the

cover to protect the Correction Level Button.

The Static Correction levels increase in strength from 1 to 5. Pushing the Correction Level Button while the Receiver

Collar is on level 5 will cause the Receiver Collar to revert to Level 1. Refer to the Function and Response Table to

choose the Static Correction level that best ﬁts your pet.

The Receiver Collar is equipped to automatically increase the level of Static Correction the longer your pet remains

in the Static Correction Zone if the collar is set at level 2 or above.

The Receiver LED Indicator Light acts as a low battery indicator, ﬂashing every 4 to 5 seconds when replacement is

required.

Step

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Comments to this Manuals

No comments

Petsafe In-Ground Fence™ User Manual Page 14

Comments to this Manuals

Related products and manuals for For pets Petsafe In-Ground Fence™