Petsafe In-Ground Fence Kit User Manual download pdf (Page 3)

www.petsafe.net 3

To Insert and Remove the Battery

Note: Do not install the battery while the Receiver Collar is on your pet.

1. Remove the screws with a Phillips screwdriver.

2. Remove the Battery Lid (1B).

3. Install a 9-volt alkaline battery (1C).

4. Replace the Battery Lid (1D).

5. Reinstall the screws. Do not over-tighten the screws.

Replacement 9-volt alkaline batteries can be found at many retailers.

To Change the Mode

Read all the steps before attempting to

change the mode.

1. With the battery installed, press the

Mode Button and release it when the

Receiver Indicator Light lights up (1E).

The Receiver Indicator Light will emit a

number of flashes representing the mode

setting (1F).

3. Change the mode by pressing and

releasing the Mode Button within

5 seconds of the previous flashes.

Prepare the Receiver Collar

Your Receiver Collar comes with short Contact Points installed. Use the long Contact Points for

pets with long or thick hair. Using the Test Light Tool, tighten the Contact Points one-quarter to

one-half turn beyond finger tight (1A). Check the tightness weekly.

1 2 3 4 5 6 7 8 ... 19 20

No comments

Petsafe In-Ground Fence Kit User Manual Page 3