Petsafe PDT00-12892 User Manual download pdf (Page 7)

www.petsafe.net 7

Operating Guide

Prepare the Handheld Transmitter

Charge the Handheld Transmitter

1. Lift the rubber dust cover protecting the Handheld

Transmitter Charging Jack.

2. Connect one of the charger connectors to the

Handheld Transmitter Charging Jack (1A).

3. Plug the charger into a standard wall outlet. The

Red LED will light up. When fully charged, the

LED will change to Green.

4. When charging is complete, be sure to replace

the rubber dust cover.

Note: Approximate battery life between charges is

40 to 60 hours, depending on frequency of use.

The Transmitter has two LED’s used to indicate

the selected dog. The Dog 1 Red LED is on the

left when holding the unit with the LED’s facing the

operator, and the Dog 2 Green LED is on the right.

The transmitter is factory set in single dog mode. To verify, press and release the Dog

Select Button multiple times. (The Red LED will blink once for each press and release.)

Transmitter Indicators

Condition Red LED

Normal Operation OFF

Low Battery - press and release any

blue correction button

3 ﬂashes every 5 seconds

Dog 1—any blue correction button

ON length of any blue correction button

press. If a Static Stimulation button

is held up to 12 continuous seconds,

then a rapid ﬂash will indicate a safety

time-out.

Charging ON

Condition Green LED

Normal Operation OFF

Dog 2—any blue correction button

ON length of any blue correction button

press. If a Static Stimulation button

is held up to 12 continuous seconds,

then a rapid ﬂash will indicate a safety

time-out.

Charging Complete ON

Step

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments

Petsafe PDT00-12892 User Manual Page 7

Comments to this Manuals

Related products and manuals for For pets Petsafe PDT00-12892