Petsafe Innotek Remote Backing Dog Manual & Automatic User Manual download pdf

Step 1

Power Up

Premium Tracking System

Quick Start Guide

RD-400

Collar Transmitter: Insert 3v lithium battery in the transmit-

ter positive (+) side out.Replace battery cap.

Handheld Receiver: Insert 9v alkaline battery into the battery clip.

Collar transmitter: Hold the keychain magnet against the red dot located on the

antenna-side of the transmitter. The LED will illuminate green; remove the key-

chain magnet.The LED will glow GREEN for one second, then flash YELLOW for

each channel count. The LED will return to flashing GREEN, indicating that the

unit is transmitting a signal.

OFF: Hold the keychain magnet against the red dot.The LED will flash RED for

one second, then shut down.

Handheld Receiver: Press the RED button on the upper left side of the meter to

turn ON; press and hold the RED button for 2 seconds;the receiver will turn OFF.

When the receiver is turned ON, the LCD display shows the current channel set-

ting.Press and release the RED button to change band setting;press and release

the BLACK button to change channel selection. (The receiver will automatically

return to the band and channel at which it was last set when turned OFF.) Channel

setting on the collar transmitter must be the same as set on the receiver.

Proper Fit:The collar fit should be snug, yet loose enough

to allow one finger to fit between the strap and the dog’s

neck. Fit is important because a loose collar may rotate

round the neck, causing inconsistent performance. It’s

okay to trim any excess strap length.

Step 2

Turn components ON/OFF

Step 3

Band and Channel Selection

Step 4

Adjust the collar

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Quick Start Guide

Step 1Power UpPremium Tracking SystemQuick Start Guide RD-400Collar Transmitter: Insert 3v lithium battery in the transmit-ter positive (+) side out.R

Page 2

RD-400 Premium Tracking SystemUnderstanding the Collar TransmitterThe collar device sends a radio frequency signal to the receiver.Theuser can cast th

Page 3

indicated and transmission strength is reduced.Replace the batteryimmediately.BatteryThe transmitter uses a 3-volt lithium battery. It can produce a l

Page 4

7.Headphone jack:Located on the right side of the receiver.The inter-nal speaker is muted when a headphone is plugged in.8.RF connector:The RF connect

Page 5 - Protective Coating

age to the antenna elements, always insert the antenna shaft into thecase as centered as possible.Replacing Receiver Antenna ElementsYour Premium Trac

Page 6

Replacement batteries Your RD-400 collar transmitter uses a 3 volt lithium battery, and thereceiver uses a 9-volt alkaline battery.These are commonly

Page 7 - 1-800-826-5527

4.Any collar worn for extended periods can cause a condition similarto bedsores, known as Pressure Necrosis.To reduce the possibility,you must do the

Page 8 - Invisible Technologies, Inc

Invisible Technologies, Inc.1-800-826-5527www.innotek.net2100215-2

Petsafe Innotek Remote Backing Dog Manual & Automatic User Manual

Browse online or download User Manual for For pets Petsafe Innotek Remote Backing Dog Manual & Automatic . Petsafe Innotek Remote Backing Dog Manual & Automatic Launchers User Manual

Summary of Contents

More documents for For pets Petsafe Innotek Remote Backing Dog Manual & Automatic

Comments to this Manuals

Petsafe Innotek Remote Backing Dog Manual & Automatic User Manual

Browse online or download User Manual for For pets Petsafe Innotek Remote Backing Dog Manual & Automatic . Petsafe Innotek Remote Backing Dog Manual & Automatic Launchers User Manual

Summary of Contents

More documents for For pets Petsafe Innotek Remote Backing Dog Manual & Automatic

Comments to this Manuals

Related products and manuals for For pets Petsafe Innotek Remote Backing Dog Manual & Automatic