Petsafe Ultrasonic Bark Control Collar User Manual download pdf (Page 68)

68 www.petsafe.net

FISVDA NORUEN

To Insert and Remove the Batteries

Note: Do not install the batteries while the Bark

Control Collar is on your dog.

1. Loosen or remove the collar from the Ultrasonic

Bark Control unit.

2. Remove the screw from the back of the unit using a

small Phillips screwdriver (A).

3. Slide the Battery Tray out (B).

4. Install two (2), 3-volt lithium CR2032 batteries

positive (+) side up (C).

5. Slide the Battery Tray back in place (D) and

secure with the screw on the back of the unit (E).

To Verify the Batteries are

Inserted Correctly

1. Slide the On/Off Switch to on ( | ).

2. The LED Light should ﬂash green once.

3. If the LED Light doesn’t ﬂash, you may have inserted the batteries backwards. Try taking them out and

turning them over, ensuring that the positive (+) side is up.

4. If the LED Light still does not ﬂash, contact the Customer Care Centre.

Replacement batteries (3-volt lithium CR2032) can be found at many retailers. Contact the Customer Care

Centre or visit our website at www.petsafe.net for a list of common retailers.

Risk of explosion if battery is replaced by an incorrect type. Do not short circuit,

mix old and new batteries, dispose of in ﬁre, or expose to water. When batteries

are stored or disposed, they must be protected from shorting. Dispose of spent batteries properly.

Battery Life

Average battery life is 1 to 3 months, depending on how often your dog barks. However, due to your dog’s

learning process, your ﬁrst batteries may not last as long as replacement batteries. To conserve battery life,

turn unit off when not in use.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 74

No comments

Petsafe Ultrasonic Bark Control Collar User Manual Page 68