Petsafe Pawz Away® Outdoor Pet Barrier User Manual download pdf (Page 11)

www.petsafe.net 11

Place one end of the Boundary Wire into the Boundary 4.

Wire Channel on the Barrier Transmitter. The wire should

touch the threads of one of the screws in the channel.

Once you have placed the wire, tighten the screw (5C).

Repeat this step to connect the other end of the

boundary wire to the opposite side of the second screw.

Make sure the bare wires do not touch each other.

Place the batteries back into the transmitter and 5.

carefully bend the wires so they ﬁ t through the groove

on the battery door (5D).

Be careful not to pull

1/4"

or tug on the wires

once you have placed

them in the channels.

Screw the battery door 6.

in place and position the

Barrier Transmitter in

your landscape.

Under normal conditions,

the batteries will operate

the transmitter for up to

one year. Test the system

Screw

Threads

Boundary

Wire End

every month

to ensure it is working properly.

Test the Barrier Area

Refer to Step 3 on page 6 for instructions on how to test the Barrier Area. Keep the

following in mind when testing the range using the wire option:

Start with the range set to 3 segments and adjust the range up to 6 segments to get your •

desired coverage. Press the (+) button 3 times to set the range to 3 segments.

When holding the Receiver Collar to check the range, walk toward the Boundary Wire •

instead of the Barrier Transmitter.

Once you are satisﬁ ed that your system is functioning properly and you are receiving

the desired barrier coverage, you are ready to bury the Boundary Wire. If the Receiver

Collar did not beep or the Test Light did not ﬂ ash, see the “Troubleshooting” section.

Install the Boundary Wire

For best results, bury the Boundary Wire to protect it. The Boundary Wire can be placed

under mulch, however, be sure that the Boundary Wire is placed in low trafﬁ c areas to

reduce the risk of wire damage.

To Bury the Boundary Wire

Cut a trench 1-3 inches deep along your planned boundary.1.

Place the Boundary Wire into the trench maintaining some slack to allow it to expand 2.

and contract with temperature variations.

Use a blunt tool such as a wooden paint stick to push the Boundary Wire into the 3.

trench. Be careful not to damage the Boundary Wire insulation.

Step

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments

Petsafe Pawz Away® Outdoor Pet Barrier User Manual Page 11

Comments to this Manuals

Related products and manuals for For pets Petsafe Pawz Away® Outdoor Pet Barrier